(1) As a kind of production machinery, the silicone machine must pass the quality management standards. If the physical test fails, notify the relevant technical enterprise competent department and inform the scheduler that it is not allowed to be put into production.

(2) The use of raw materials must have a laboratory inspection and analysis report, which can be used only after being qualified, and the inspection report should be archived.

(3) Under normal circumstances, the material must be confirmed before the use of silicone products, and the dispatcher must be notified to use it. For products that are in direct contact with food or have special requirements, there should be technical requirements and technical documents should be archived.

(4) Product inspection should be based on standards and implement three standards (national standards, ministerial standards, and corporate standards).

(5) To confirm the product grade, the quality inspector should follow the standard, and the quality control can change the product design grade according to the technical development standard. No one else has the right to change the level of Chinese products or privately change the level of traditional products.

(6) The inspector must be responsible for the quality of the products, classified by grade, stored in designated locations, and stored in batches and grades. If the product has a defect of more than 15% of the product

(7) The silicone injection molding engineer should immediately convene dispatchers, process technicians, administrators and technicians to discuss and analyze several aspects such as total quality management. To create the reason for the technician, the solution, the worker who publicizes the job, the injection workshop engineer should explain it.